Moldboard Protection

Nothing better than this:

Kenco fabricates these Moldboard Protector Caps welding their tungsten-carbide impregnated wear strips at a bevel to AR500 wear plates with the bolt holes in them. So the Cap rests on top of the moldboard and is attached using longer plow bolts which bolt through the cutting edge and moldboard. As a result the moldboard is 'sandwiched' between the cutting edge and moldboard Protector Cap thus completely protected from wear.

A less expensive option:

Purchase a Kenco tungsten-carbide impregnated wear strip the width of the bucket bevel and weld it to the bucket. Then use Kenco's wear patch to cover the top of the moldboard.

Back to Loader Buckets

 

Credit Application

Inquire About Our Products

Use this form to get more information about our products.

  • There were some problems with your form submission:

Thanks for your message! We will get back to you ASAP!

* indicates a required field